Influence of high temperature strain grid wire creep on strain measurement precision and its compensation

WANG Wen-rui; WANG Gang; HU Ting; ZHANG Jia-ming

doi:10.13374/j.issn2095-9389.2017.01.012

Volume 39 Issue 1

Jan. 2017

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2017 > 39(1): 88-95

WANG Wen-rui, WANG Gang, HU Ting, ZHANG Jia-ming. Influence of high temperature strain grid wire creep on strain measurement precision and its compensation[J]. Chinese Journal of Engineering, 2017, 39(1): 88-95. doi: 10.13374/j.issn2095-9389.2017.01.012

Citation:

WANG Wen-rui, WANG Gang, HU Ting, ZHANG Jia-ming. Influence of high temperature strain grid wire creep on strain measurement precision and its compensation[J]. Chinese Journal of Engineering, 2017, 39(1): 88-95. doi: 10.13374/j.issn2095-9389.2017.01.012

Citation:

PDF( 3868 KB)

Influence of high temperature strain grid wire creep on strain measurement precision and its compensation

doi: 10.13374/j.issn2095-9389.2017.01.012

1) School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China
2) Research Center for Aerospace Vehicles Technology, University of Science and Technology Beijing, Beijing 100083, China
3) Beijing Foton Cummins Engine Co. Ltd, Beijing 102206, China

Received Date: 2016-03-15

Abstract

Abstract

Contact strain measurement is a tool for studying the high temperature mechanical behavior of components and materials. The measurement precision is the key point of the high temperature strain measurement field, where creep is the main factor that affects the measurement precision at high temperature. In this paper, the creep characteristics of strain gauges were analyzed according to the material mechanism of creep by a high temperature strain measurement system. A grating creep model was obtained from the creep rule and experiment measurement results. Based on the grating creep model, the influence factors of strain gauge creep output were studied by the finite element model. Finally, a compensation model of high temperature strain creep was established to improve this high temperature strain measurement precision, and it was validated by experimental data.
- high temperature,
- creep,
- strain gauges,
- strain measurement,
- precision

FullText(HTML)

References(5)

References

[1]	Wang W R, Zhang J M, Ren X, et al. Research and calibration experiment of characteristic parameters of high temperature resistance strain gauges. Sens Transducers, 2013, 159(11):324
[7]	Li J H, Han L, Duan J A, et al. Interface mechanism of ultrasonic flip chip bonding. Appl Phys Lett, 2007, 90(24):242902
[8]	Li J H, Wang D, Ji D A, et al. Structural design and control of a small-MRF damper under 50 N soft-landing applications. IEEE Trans Ind Inf, 2015, 11(3):612
[9]	Rohrbach C, Lexow J. Miniature force transducers with strain gauges. Measurement, 1986, 4(3):93
[10]	Mittmann H U, Czaika N, Czichos H. A new device for simultaneous measurement of friction force, normal force and friction coefficient. Wear, 1975, 31(1):179