Fabrication of SiC/C Functionally Graded Material

CAO Wenbin; WU Anhua; LI Jiangtao; GE Changchun

doi:10.13374/j.issn1001-053x.2001.01.035

Volume 23 Issue 1

Aug. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2001 > 23(1): 32-34

CAO Wenbin, WU Anhua, LI Jiangtao, GE Changchun. Fabrication of SiC/C Functionally Graded Material[J]. Chinese Journal of Engineering, 2001, 23(1): 32-34. doi: 10.13374/j.issn1001-053x.2001.01.035

Citation:

CAO Wenbin, WU Anhua, LI Jiangtao, GE Changchun. Fabrication of SiC/C Functionally Graded Material[J]. Chinese Journal of Engineering, 2001, 23(1): 32-34. doi: 10.13374/j.issn1001-053x.2001.01.035

CAO Wenbin, WU Anhua, LI Jiangtao, GE Changchun. Fabrication of SiC/C Functionally Graded Material[J]. Chinese Journal of Engineering, 2001, 23(1): 32-34. doi: 10.13374/j.issn1001-053x.2001.01.035

Citation:

CAO Wenbin, WU Anhua, LI Jiangtao, GE Changchun. Fabrication of SiC/C Functionally Graded Material[J]. Chinese Journal of Engineering, 2001, 23(1): 32-34. doi: 10.13374/j.issn1001-053x.2001.01.035

PDF( 430 KB)

Fabrication of SiC/C Functionally Graded Material

doi: 10.13374/j.issn1001-053x.2001.01.035

Laboratory of Special Ceramics and P/M, UST Beijing, Beijing 100083, China

Received Date: 2000-06-29

Abstract

Abstract

The thermal stress in SiC/C FGM in steady temperature field was analyzed based on the classical lamination theory and thermo-elastic mechanics. The optimum composition distribution parameters for fabricating SiC/C FGM were obtained through the above analysis. SiC/C FGM F4 and F7 were fabricated successfully by hot pressing. The microstructure was observed by SEM. Thermal shock resistance of SiC/C FGM was repeatedly tested by quenching from 500℃ into water with room temperature. It has been proved that FGM F7, which was fabricated with the optimized parameters, has better thermal shock resistance.
- SiC/C,
- functionally graded material,
- thermal stress relaxation