含固相銅冶煉渣的黏度計算及其應用

盛力; 李江濤; 張建坤; 張家靚; 張立峰; 侯新梅

doi:10.13374/j.issn2095-9389.2017.01.006

含固相銅冶煉渣的黏度計算及其應用

doi: 10.13374/j.issn2095-9389.2017.01.006

盛力¹,
李江濤^1,2,
張建坤^1,2,
張家靚^1,3, ,,
張立峰^1,3,
侯新梅¹

1) 北京科技大學冶金與生態工程學院, 北京 100083
2) 謙比希銅冶煉有限公司, 謙比希 999134, 贊比亞
3) 稀貴金屬綠色回收與提取北京市重點實驗室, 北京 100083

基金項目:

中央高校基本科研業務費資助項目（FRF-TP-15-068A1）

詳細信息

中圖分類號: TF811
計量
- 文章訪問數: 762
- HTML全文瀏覽量: 302
- PDF下載量: 32
- 被引次數: 0
出版歷程
- 收稿日期: 2016-07-05

Viscosity calculation and its application of the copper smelting slag containing solid phase

1) School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China
2) Chambishi Copper Smelter Limited, Chambishi 999134, Zambia
3) Beijing Key Laboratory of Green Recycling and Extraction of Metals, Beijing 100083, China

摘要

摘要: 利用Roscoe方程，結合FactSage的多元多相平衡計算和純液相渣黏度計算功能可對含固相熔渣的黏度進行計算.本研究針對基于銅冶煉渣的FeO-SiO₂-Fe₃O₄-CaO-Al₂O₃-MgO系，首先根據相似爐渣的黏度測定值對Roscoe方程中的參數進行擬合，同時驗證了該方法在計算所研究體系時的準確性.基于所得的計算模型考察不同組分含量對平衡相組成及黏度的影響規律，并總結獲得合理的渣型配比.當爐渣中各組分的質量分數分別控制在FeO 40%~60%、SiO₂ 25%~40%、Fe₃O₄ 0%~15%、CaO 0%~10%、Al₂O₃ 0%~8%和MgO 0%~4%時，可在冶煉過程中得到流動性較好、固體量較少的熔渣.
- 銅冶煉 /
- 渣 /
- 黏度 /
- 固相 /
- 計算
Abstract: The viscosity of solid-containing slags can be calculated using the Roscoe equation combined with the calculation functions of multi-component & multi-phase equilibria and pure-liquid slag's viscosity in FactSage software. An FeO-SiO₂-Fe₃O₄-CaO-Al₂O₃-MgO system used in copper smelting was studied in this paper. Firstly, the parameters of the Roscoe equation were fitted using the measured viscosities of analogous slag in the literature, and the accuracy of viscosity calculated by the method for this slag system was verified additionally. Then, the effect of slag components' contents on the equilibrium phase-composition and viscosity was investigated based on the calculation model. Accordingly, the reasonable proportions of components in the slag were obtained. When the mass fractions of slag components are FeO 40%~60%, SiO₂ 25%~40%, Fe₃O₄ 0%~15%, CaO 0%~10%, Al₂O₃ 0%~8%, and MgO 0%~4%, the molten slag with good liquidity and fewer solids can be obtained in the smelting process.
- copper smelting /
- slag /
- viscosity /
- solid phase /
- calculations

HTML全文

參考文獻(20)

[3]	Shiraishi Y, Ikeda Y, Tamura A, et al. On the viscosity and density of the molten FeO-SiO₂ system. Trans Jpn Inst Met, 1978, 19(5):264
[4]	Chen M, Raghunath S, Zhao B J. Viscosity measurements of "FeO"-SiO₂ slag in equilibrium with metallic Fe. Metall Mater Trans B, 2013, 44(3):506
[5]	Kucharski M, Stubina N M, Toguri J M. Viscosity measurements of molten Fe-O-SiO₂, Fe-O-CaO-SiO₂, and Fe-O-MgO-SiO₂ slags. Can Metall Q, 1989, 28(1):7
[6]	Ji F Z, Du S C, Seetharaman S. Experimental studies of the viscosities in the CaO-Fe_n O-SiO₂ slags. Metall Mater Trans B, 1997, 28(5):827
[7]	Chen M, Raghunath S, Zhao B J. Viscosity of SiO₂-"FeO"-Al₂O₃ system in equilibrium with metallic Fe. Metall Mater Trans B, 2013, 44(4):820
[8]	Seok S H, Jung S M, Lee Y S, et al. Viscosity of highly basic slags. ISIJ Int, 2007, 47(8):1090
[9]	Jeffrey D J, Acrivos A. The rheological properties of suspensions of rigid particles. AIChE J, 1976, 22(3):417
[10]	Roscoe R. The viscosity of suspensions of rigid spheres. Br J Appl Phys, 1952, 3(8):267
[11]	Wright S, Zhang L, Sun S Y, et al. Viscosities of calcium ferrite slags and calcium alumino-silicate slags containing spinel particles. J Non Cryst Solids, 2001, 282(1):15
[12]	Wright S, Zhang L, Sun S Y, et al. Viscosity of a CaO-MgO-Al₂O₃-SiO₂ melt containing spinel particles at 1646K. Metall Mater Trans B, 2000, 31(1):97
[13]	Kondratiev A, Jak E. Modeling of viscosities of the partly crystallized slags in the Al₂O₃-CaO-"FeO" SiO₂ system. Metall Mater Trans B, 2001, 32(6):1027
[14]	Kondratiev A, Jak E. Predicting coal ash slag flow characteristics (viscosity model for the Al₂O₃-CaO-‘FeO’-SiO₂ system). Fuel, 2001, 80(14):1989
[15]	Bale C W, Chartrand P, Degterov S A, et al. FactSage thermochemical software and databases. Calphad, 2002, 26(2):189
[17]	Keene B J, Mills K C. Densities of Molten Slags (Chapter 8), Slag Atlas. Dusseldorf:Verlag Stahl-Eisen, 1995
[18]	Pelton A D, Chartrand P. The modified quasi-chemical model:Part Ⅱ. Multicomponent solutions. Metall Mater Trans A, 2001, 32(6):1355
[19]	Seetharaman S, Mukai K,Du S C. Viscosities of slags:an overview//VⅡ International Conference on Molten Slags Fluxes and Salts. The South African Institute of Mining and Metallurgy, 2004
[20]	Seki K, Oeters F. Viscosity measurements on liquid slags in the system CaO-FeO-Fe₂O₃-SiO₂. Trans Iron Steel Inst Jpn, 1984, 24(6):445
[21]	Zhang H W, Sun F, Shi X Y, et al. The viscous and conductivity behavior of melts containing iron oxide in the FeOt-SiO₂-CaO-Cu₂O system for copper smelting slags. Metall Mater Trans B, 2012, 43(5):1046
[23]	Mackey P J. The physical chemistry of copper smelting slags:a review. Can Metall Q, 1982, 21(3):221
[24]	Higgins R, Jones T J B. Viscosity characteristics of Rhodesian copper smelting slags. Bull Inst Min Metall, 1963, 72:825