<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">
  • 《工程索引》(EI)刊源期刊
  • 中文核心期刊
  • 中國科技論文統計源期刊
  • 中國科學引文數據庫來源期刊

留言板

尊敬的讀者、作者、審稿人, 關于本刊的投稿、審稿、編輯和出版的任何問題, 您可以本頁添加留言。我們將盡快給您答復。謝謝您的支持!

姓名
郵箱
手機號碼
標題
留言內容
驗證碼

再生鉛低溫堿性固硫熔煉的實驗研究

胡宇杰 唐朝波 唐謨堂 陳永明

胡宇杰, 唐朝波, 唐謨堂, 陳永明. 再生鉛低溫堿性固硫熔煉的實驗研究[J]. 工程科學學報, 2015, 37(5): 588-594. doi: 10.13374/j.issn2095-9389.2015.05.008
引用本文: 胡宇杰, 唐朝波, 唐謨堂, 陳永明. 再生鉛低溫堿性固硫熔煉的實驗研究[J]. 工程科學學報, 2015, 37(5): 588-594. doi: 10.13374/j.issn2095-9389.2015.05.008
HU Yu-jie, TANG Chao-bo, TANG Mo-tang, CHEN Yong-ming. Extraction of lead from secondary lead through a low-temperature alkaline and sulfur-fixing smelting process[J]. Chinese Journal of Engineering, 2015, 37(5): 588-594. doi: 10.13374/j.issn2095-9389.2015.05.008
Citation: HU Yu-jie, TANG Chao-bo, TANG Mo-tang, CHEN Yong-ming. Extraction of lead from secondary lead through a low-temperature alkaline and sulfur-fixing smelting process[J]. Chinese Journal of Engineering, 2015, 37(5): 588-594. doi: 10.13374/j.issn2095-9389.2015.05.008

再生鉛低溫堿性固硫熔煉的實驗研究

doi: 10.13374/j.issn2095-9389.2015.05.008
基金項目: 

國家重點自然科學基金資助項目(51234009)

湖南省自然科學基金資助項目(13JJ5035)

湖南省教育廳科研基金資助項目(14C0349)

詳細信息
    通訊作者:

    唐朝波,E-mail:tangchaobo9043@163.com

  • 中圖分類號: TF803

Extraction of lead from secondary lead through a low-temperature alkaline and sulfur-fixing smelting process

  • 摘要: 針對我國傳統再生鉛生產工藝所存在的熔煉溫度高、能耗大、鉛和低濃度SO2煙氣污染嚴重等弊端,在對NaOH-C-PbSO4-ZnO低溫堿性煉鉛體系進行理論分析的基礎上,提出了一種再生鉛的低溫堿性固硫熔煉新工藝.以廢鉛酸蓄電池膠泥(以下簡稱膠泥)為實驗原料,采用單因素實驗法分別考察NaOH用量、熔煉溫度、焦粉用量及固硫劑ZnO用量對金屬鉛直收率和ZnO固硫率的影響.獲得優化實驗條件如下:m(NaOH)/m(膠泥)=60%,熔煉溫度為860℃,m(焦粉)/m(膠泥)=10%,m(ZnO)=m(理論量).在此優化條件下進行綜合擴大實驗,鉛的直收率為99.09%,獲得粗鉛品位為98.86%,ZnO固硫率為93.37%.X射線衍射圖譜分析可知,反應后原料中硫主要以ZnS的形式固定在渣中,NaOH絕大部分轉變為Na2CO3,生產過程中無SO2氣體排放.

     

  • 加載中
計量
  • 文章訪問數:  355
  • HTML全文瀏覽量:  118
  • PDF下載量:  10
  • 被引次數: 0
出版歷程
  • 收稿日期:  2014-02-09
  • 網絡出版日期:  2021-07-10

目錄

    /

    返回文章
    返回
    <th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
    <progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
    <th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
    <progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
    <span id="5nh9l"><noframes id="5nh9l">
    <span id="5nh9l"><noframes id="5nh9l">
    <span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
    <th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
    <progress id="5nh9l"><noframes id="5nh9l">
    259luxu-164