Influence of heat treatments at temperatures below the γ′ solvus on γ′ phase in nickel-base superalloy GH720Li
-
摘要: 對難變形鎳基高溫合金GH720Li進行了亞固溶處理、亞固溶+單時效(650℃,24 h→空冷)或雙時效處理(650℃,24 h→空冷+760℃,16 h→空冷)以及870℃時效3000 h條件下γ′相演變規律的研究.發現一次γ′相受亞固溶處理影響較大,發生部分回溶的程度隨固溶溫度升高而增大,時效處理使一次γ′相向球形或近球形轉變;二次和三次γ′相在亞固溶保溫過程中完全回溶,在時效處理時補充析出明顯且析出數量和區域隨固溶溫度升高而增大;870℃長期時效時,合金組織逐漸均勻,二次和三次γ′相完全回溶,晶界一次γ′相時效500 h后有所粗化,合金硬度先降低而后保持不變.Abstract: The microstructurM evolution of γ′ phase was investigated in difficult-to-deform nickel-base superalloy GH720Li subjected to subsolvus solution heat treatment, 650℃ for 24 h → air cooling or 650 ℃ for 24 h→ air cooling + 760 ℃ for 16 h → air cooling after subsolvus solution treatment, and long time aging at 870 ℃ for 3000 h. It is found that the primary γ′ phase is affected most significantly by subsolvus solution treatment, the degree of partial dissolution increases with increasing solution temperature, and aging treatment makes the primary γ′ phase turn to sphere or near sphere. However, the secondary and the tertiary γ′ phase fully dissolve into the matrix during subsolvus solution treatment, re-precipitation during the aging is obvious, and the amount and zone increase with increasing solution temperature. When long time aging at 870 ℃ the microstructure uniformity gradually improves, and the secondary and tertiary γ′ phase dissolve. The primary γ′ phase at grain boundaries coarsens a little after 500 h. Besides, the hardness decreases with the aging time prolonging at 870℃ before keeping unchanged.
-
Key words:
- superalloys /
- nickel alloys /
- heat treatment /
- phase transitions /
- aging
-

計量
- 文章訪問數: 185
- HTML全文瀏覽量: 27
- PDF下載量: 6
- 被引次數: 0