Hydrothermal preparation of nanoflake structured titanium dioxide photocatalysts from electric furnace molten slag
-
摘要: 采用水熱法,以氫氧化鈉為分離劑,從含鈦電爐熔分渣中成功制備出納米片狀結構二氧化鈦光催化劑,并探討了水熱反應時間、水熱溫度以及堿液濃度對分離提取納米片狀結構二氧化鈦的影響.隨著水熱反應時間的延長,水熱溫度以及氫氧化鈉溶液濃度的提高,從含鈦電爐熔分渣中分離提取的二氧化鈦結晶度越好,微觀形貌更趨近于納米片狀結構.水熱法處理含鈦電爐熔分渣的最佳反應條件是:水熱溫度高于180℃,水熱反應時間大于24 h,堿液濃度達到12 mol·L-1.以制備得到的納米片狀結構二氧化鈦為光催化劑,在氙燈光照90 min后,甲基藍降解率可達81.1%.Abstract: Nanoflake structured titanium dioxide was successfully prepared from electric furnace molten slag by using a hydrothermal method under the condition of alkaline solution. The effects of hydrothermal temperature, reaction time and sodium hydroxide solution concentration on the titanium extraction and morphology were investigated. Relatively pure and better crystallized nanoflake structured titanium dioxide can be obtained with increasing reaction temperature, time and alkaline solution concentration. The optimum preparing conditions are that the hydrothermal temperature is above 180℃, the reaction time is above 24 h and the concentration of NaOH solution is 12 mol·L-1. Using the as-prepared TiO2 as a photocatalyst, the degradation rate of methyl blue is above 81.1% under a xenon lamp for 90 min.
-
Key words:
- photocatalysts /
- titanium dioxide /
- nanostructures /
- hydrothermal synthesis /
- slags /
- waste utilization
-

計量
- 文章訪問數: 261
- HTML全文瀏覽量: 74
- PDF下載量: 5
- 被引次數: 0