<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">

PSA制氧過程產品氣流量對其氧氣體積分數的影響

Influence of product flow rate on O2 volume fraction in PSA oxygen generation process

  • 摘要: 為了提高小型兩床變壓吸附(PSA)制氧機在變產品氣流量下的氧氣體積分數,建立了改進的Skarstrom兩床循環PSA制氧實驗裝置,研究了產品氣流量對其氧氣體積分數的影響。研究結果表明,在低產品氣流量運行條件下,通過提高清洗氣總氧量與原料氣總氧量之比(P/F)以及降低最高吸附壓力與最低解吸壓力之比(θ)可消除氧氣返混的不利影響;在高產品氣流量運行條件下,通過提高P/Fθ可以提高實驗裝置中分子篩的工作能力,進而提高產品氣中的氧氣體積分數。在此基礎上,對低和高產品氣流量運行條件下的P/Fθ進行了調節,分別將產品氣流量為3.55 L·min?1和19.88 L·min?1時的氧氣體積分數從92.4%增加至了95.7%和從74.0%增加至了74.9%。本文的研究結果可為變產品氣流量下PSA制氧工藝參數優化提供參考。

     

    Abstract: In recent decades, the small-scale pressure swing adsorption (PSA) oxygen generator has been widely used in the fields of home medical and hospital oxygen supply, anoxic environments, and plateau environments due to its cost effectiveness, operational flexibility, and adequate O2 volume fraction. The flexible optimization of PSA oxygen generation in response to changes in product demand is an important factor in its practical performance. To study the influence of a variable product flow rate on O2 volume fraction in the small-scale PSA oxygen generator, experimental equipment was set up, which consisted of a modified Skarstrom-cycle two-bed PSA system. The research results show that variations in the parameters at the lower product flow rate (≤10.37 L·min?1) may have a negative effect on oxygen countercurrent mixing, which can impair oxygen generation, and at higher product flow rates (≥13.57 L·min?1) may cause the negative effect of nitrogen breakthrough, which decreases the working capacity of the adsorbents in the bed. The O2 volume fraction at the lower product flow rate was improved by increasing the ratio of total oxygen in the purge gas to the total oxygen in the feed gas (P/F) and by decreasing the ratio of the highest adsorption pressure to the lowest desorption pressure (θ) during a cycle to suppress oxygen countercurrent mixing. The O2 volume fraction at the higher product flow rate was improved by increasing the P/F and θ values to improve the working capacity of the adsorbents in the bed. Accordingly, adjustments are made in the P/F and θ values at the lower and higher product flow rates to achieve optimal oxygen generation performances, enhancing the O2 volume fraction from 92.4% and 74.0% to 95.7% and 74.9% at the respective product flow rates of 3.55 L·min?1 and 19.88 L·min?1. This work is meaningful for the optimization of the parameters of the PSA oxygen production process at variable product flow rates.

     

/

返回文章
返回
<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">
259luxu-164