<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">

Ni-Fe-Cr基高溫合金表面AICrN涂層制備及高溫氧化性能

Preparation and high temperature oxidation of AlCrN coatings on the surfaces of Ni-Fe-Cr-based superalloys

  • 摘要: 采用陰極弧離子鍍法在Ni-Fe-Cr基高溫合金表面制備了AlCrN涂層.通過電子掃描電鏡、能譜儀、X射線衍射儀和X射線光電子譜儀等分析了AlCrN涂層表面和界面的形貌、能譜、物相以及結合能譜,并進行了800和900℃高溫氧化實驗,研究了AlCrN涂層抗高溫氧化性能及其機理.實驗結果表明:AlCrN涂層主要成分為Al、Cr和N元素,添加Al元素后表現出較強的AlN擇優取向;Al2p峰譜為Al—N和Al—O結合鍵,Cr2p峰譜為Cr—O和Cr—N結合鍵,N1s峰譜以Cr—N和Al—N的形態存在,另外含有少量的N—Cr—O和N—Al—O結合鍵;經過高溫氧化后AlCrN涂層表面氧化物為Cr2O3,對高溫合金基體有良好的保護作用.

     

    Abstract: An AlCrN coating was prepared on the surface of a Ni-Fe-Cr-based superalloy by cathodic arc ion plating. The morphology, energy spectra, phase composition, and binding energy of the coating surface and interface were analyzed by means of scanning electron microscopy, energy disperse spectroscopy, X-ray diffraction and X-ray photoelectron spectroscopy. The high temperature oxidation resistance and mechanism of the coating were studied by high temperature oxidation tests at 800 and 900℃. It is found that the coating is mainly composed of Al, Cr and N elements, showing strong preferred orientation of AlN after adding Al element. The peak spectrum of Al2p is Al-N and Al-O binds, the peak spectrum of Cr2p is Cr-O and Cr-N binds, and the peak spectrum of N1s is in the form of Cr-N and Al-N, also contains a small amount of N-Cr-O and N-Al-O bonds. The oxide in the coating surface is Cr2O3 after high temperature oxidation, which has good protective effect on the Ni-Fe-Cr-based superalloy.

     

/

返回文章
返回
<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">
259luxu-164