<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">

TiO2-SiO2復合氣凝膠的常壓干燥制備及光催化降解含油污水活性

Photocatalytic activity of monolithic TiO2-SiO2 composite aerogels obtained by ambient drying for degrading oily wastewater

  • 摘要: 以鈦酸四丁酯和正硅酸乙酯為原料,利用溶膠凝膠工藝制備出不同硅含量的TiO2-SiO2復合醇凝膠.結合老化液浸泡和小孔干燥工藝,在常壓下干燥得到完整的TiO2-SiO2復合氣凝膠塊體.采用掃描電子顯微鏡、BET比表面積測試、X射線粉末衍射等測試手段對復合氣凝膠的微觀結構和物化性能進行了測試和表征.測試結果表明,復合氣凝膠具有良好的性能,Ti和Si元素在氣凝膠中分布均勻.隨著SiO2含量的增加,復合氣凝膠的密度逐漸變小,比表面積增大,孔隙率增加,轉變為銳鈦礦相的相變溫度升高.經高溫煅燒晶化處理,復合氣凝膠轉變為銳鈦礦相結構.以乳化后的渤海原油水溶液作為含油污水模擬溶液,測試了復合氣凝膠對含油污水的催化降解性能.污水降解結果顯示復合氣凝膠對渤海原油污水具有較好的催化降解活性.在SiO2摩爾分數低于30%時,隨著硅含量的增加,復合氣凝膠的光催化降解率升高;但當SiO2摩爾分數高于30%后,繼續增加SiO2摻入量,反而造成復合氣凝膠催化能力下降.對于SiO2摩爾分數為30%的復合氣凝膠,獲得了最佳的催化降解效果,90 min催化降解率達95%.

     

    Abstract: TiO2-SiO2 composite aerogels with different contents of SiO2 were synthesized through a sol-gel route with tetrabutyl titanate and tetraethyl orthosilicate as the raw materials. In combination with solution aging and pinhole drying processes, monolithic TiO2-SiO2 composite aerogels were prepared via ambient drying, and their microstructure and the physicochemical properties were studied by scanning electron microscopy, BET method and X-ray diffraction analysis. It is found that the composite aerogels have low density, high specific surface area and show uniform element distribution of Ti and Si. With the increase of SiO2 content, the density of the composite aerogels decreases gradually, the specific surface area and the porosity increase, and the phase transition temperature to anatase rises. By calcination at high temperature, the composite aerogels change into anatase structure. The photocatalytic properties of the calcined samples were investigated by degradation experiments of the aqueous emulsion of crude oil from the Bohai Sea. The experimental results show that the photocatalytic degradation efficiency of the calcined sample increases with the mole fraction of SiO2 increasing till 30%, but it decreases when the mole fraction of SiO2 is above 30%. The best photocatalytic performance is acquired when the calcined sample contains 30% SiO2, with the catalytic degradation efficiency for 90 min being up to 95%.

     

/

返回文章
返回
<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">
259luxu-164