<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">

高溫浸礦菌sulfolobus的生長及浸礦性能

Thermophilic microorganism sulfolobus growth and leaching chalcopyrite properties

  • 摘要: 系統地研究了耐高溫菌sulfolobus的生長特性.sulfolobus在65℃以上能良好地生長,并對亞鐵和元素硫均具有較好的氧化作用;在75℃時,sulfolobus氧化Fe2+和元素硫的活性最強,細菌的生長曲線和細菌氧化Fe2+和元素硫的趨勢一致.給出了細菌生長過程溶液SO42-和pH的變化趨勢;以黃銅礦精礦為培養基對sulfolobus進行了適應性培養,并在75℃下進行了黃銅礦搖瓶浸出研究.結果顯示:適應性馴化后的sulfolobus在黃銅礦精礦上生長與浸礦性能良好;當礦漿質量分數在10%以下,浸出150h,Cu浸出率可達90%以上;而礦漿質量分數在15%以上時,浸出350h,浸出率僅80%.同時還研究了浸出體系溶液氧化還原電位Eh和pH隨時間的變化規律.

     

    Abstract: The sulfolobus, a thermophilic microorganism, can grow at high temperature up to 65℃. It has good ability to oxidizing element sulfur and ferrous ion and can meet the high temperature demand in dump leaching and chalcopyrite stirring leaching in a reactor. The culture results show that at 75℃the sulfolobus has more adapted to the environment than below and above the temperature. The changing tends of the solution pH,redox potential, SO42- concentration and ferrous oxidation rate with time in bio culture as well as in bioleaching of chalcopyrite concentrate were elucidated. The bioleaching experiments show that using the trained sulfolobus strains at 75℃ in the shake blasting when the slurry mass fraction is below 10%, the chalcopyrite concentrate leaching rate could up to 90% after 150 h leaching. But when slurry mass fraction is up to 15%, after 350 h leaching, the leaching rate is only 80%. It demonstrates that the slurry mass fraction has apparently effect on the leaching results.

     

/

返回文章
返回
<th id="5nh9l"></th><strike id="5nh9l"></strike><th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th><strike id="5nh9l"></strike>
<progress id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"><noframes id="5nh9l">
<th id="5nh9l"></th> <strike id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span>
<progress id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"><noframes id="5nh9l"><span id="5nh9l"></span><strike id="5nh9l"><noframes id="5nh9l"><strike id="5nh9l"></strike>
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"><noframes id="5nh9l">
<span id="5nh9l"></span><span id="5nh9l"><video id="5nh9l"></video></span>
<th id="5nh9l"><noframes id="5nh9l"><th id="5nh9l"></th>
<progress id="5nh9l"><noframes id="5nh9l">
259luxu-164