楔橫軋軋制瞬時轉速的計算機測量和軋制半徑的確定

Computer Measuring of Rolling Rotating Speed and Rolling Radium in Wedge Cross Rolling

摘要: 介紹了用APPLE-Ⅱ微型計算機和光柵脈沖發生器測量楔橫軋軋制轉速和確定軋制半徑的普遍方法,并指出在條件許可的情況下,只要盡量選用高碼道的脈沖發生器就可以提高測量精度。且以某錐體零件毛坯軋制的軋制轉速和軋制半徑測量為例,證明了這一方法是可行的。

Abstract: This paper introduces a new way that can measure the speed of wedge cross rolling and rolling radium with Apple-Ⅱ computer. It says, the precision of measure can be increased if the precision of equipment is enough. The way is proved to be excellent by measuring the rotating speed and rolling radium of some semifinished spare part as an example.